What causes the tooth skipping of the synchronous belt? Why does the timing belt always run off? Why do the teeth of the timing belt wear so fast? Why does the timing belt degummed and turned yellow during storage? How to deal with it?

[About the installation of polyurethane timing belt] 1. Is there an easy way to install your timing belt? No, our timing belt cannot be pried close to the pulley like a rubber V-belt. It must be installed in accordance with our installation instructions. 2. What causes tooth skipping? The tooth profile or pitch of the timing belt and the pulley do not match. 3. Why is the timing belt always running off track? It is possible that the pulleys are not aligned during installation. It may also be the problem of belt straightness. Using a belt with good straightness, the equipment can avoid deviation from left to right when conveying items. In addition, products with high straightness will have relatively low belt wear and machine noise. 4. Why do the teeth of the timing belt wear so fast? The belt is pedaled too tightly, the pulley pitch is not standard, and the equipment is overloaded. 5. Why does your timing belt make louder noises when it is running? There may be a problem with the pulley and belt matching. [About storage of polyurethane timing belt] 1. Why does the timing belt degummed and turned yellow during storage? Due to the nature of the material itself, polyurethane timing belts will experience long storage time, yellowing due to improper storage, degumming, and aging. These are normal phenomena, not the quality of the belt itself. 2. How to deal with the timing belt degumming? If the storage time is short and degumming occurs, it should be sent back to check whether it is a quality problem of our company's products, and the glue can be refilled. If the storage time is long and automatic degumming occurs, it is recommended to scrap it and do it again. Because under this condition, the bottom belt is also aging to an unusable level at the same time. 3. Some of our straps are degummed. Could you please re-glue them for us? What is the cost? Our company has to look at the specific date of manufacture of the strap, as well as the degree of wear of the strap. The cost is also determined by the specific size. 4. What should I do if the timing belt turns yellow? If the belt is not stored in a standard sealed package and it is oxidized, it will turn yellow to a certain extent. At this time, it should be based on the belt itself. If it does not affect the material properties of the belt itself, it can be used.